New Products - FANN®

Oil Well Cement Testing

Oil well cement is required to meet API specifications and Fann has the instruments you need for physical and chemical testing.

Blenders and Mixers

Blenders and Mixers

Preparation of drilling fluids and samples used in fluid analysis requires a variety of high speed mixers and blenders. These mixers must conform to American Petroleum Institute Specification 13A.

Compressive Strength

Compressive Strength

Fann instruments allow standard crush or non-destructive compressive-strength tests to be performed under simulated downhole pressure and temperature conditions.

Density

Density

Density is a measurement of fluid weight per unit of volume. Fann has instruments for the lab and field to make that measurement.

Fluid Loss Test

Fluid Loss Test

A fluid-loss test determines the relative effectiveness of a cement slurry to retain or lose its water phase. Controlling fluid loss is important in pumping the slurry to its final location.

Static Gel Strength

Static Gel Strength

Chemical reactions occur within an oil well cement mixture as it becomes a solid. Fann has instruments that perform consistency tests and static gel strength tests on cement slurry samples.

Thickening Time Tests

Thickening Time Tests

The thickening time of a slurry is calculated to determine the time required to mix and pump the slurry.

Ultrasonic Cement Testing

Ultrasonic Cement Testing

An ultrasonic compressive-strength test is used to help plan a cementing schedule for a well.

Viscosity

Viscosity

Viscosity is a measure of the resistance of a fluid which is being deformed by either shear stress or tensile stress, measured with viscometers and rheometers. Fann has a wide selection.

Wettability

Wettability

Wettability tests evaluate spacers and pre-flushes that water-wet surfaces where cement needs to bond or where the surfaces are exposed to non-aqueous fluids, specifically oil and synthetic-based drilling fluids.